SALE 9% OFF
If you need to send UPS/Fedex/TNT/DHL,please contact us.We need to discuss the freight with you.
The trianglelab has always been concerned about product quality.We are developing products and working hard to improve the quality.We will not abandon our reputation because of many cheap products on the market.It is believed that only high quality products can ensure the quality of your work and bring safety to your work.
Some of our products may be more expensive than others,but please believe in our quality and believe that you will not regret when you receive the goods.
Double-sided Textured PEI Spring Steel Sheet for 3D printers
This will be an incredible product ,It allows you to experience unparalleled happiness when you pick up your pieces.
▉Benefits:
No more 3M Masking tape
No more glue stic
No more ABS juice
No more PEI sheet replacement
Easy to print
Easy to remove by bending and popping it off
Easy to maintain
Double-sided
Lower runing cost especially for printing farm
Genuine PEI powder coating
Hardened steel spring sheet never diforming
Possible to adding ABL for some low-cost printers
*Make adding inductive Z-probe possible
If you need AUTO Bed Leveling Z-probe(M8 inductive proximity sensor )
▉Material Compatibility:
PLA ABS PETG TPU PVA etc.
▉SIZE:
235x235MM 9.5″x10″ (for Ender 3 3d Printer)
Other size available:
165x165MM 6.5″x6.5″ (for Creality Ender 2)
220x220MM 8.7″X8.7″ （for Anet A8, Robo R2, Wanhao Duplicator6 ETC.）
241x252MM 9.25″X9.25″ (for prusa)
▉Printer Compatibility:
Ender 3 4 5 3d Printer
Similar bed size printer with Magnetic Base.
▉Maintenance:
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE, and RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed.
▉Attention:
It is possible to mount our kits on a larger bed, just be aware that you will have a reduced printing area. It is also possible to mount our kits on slightly smaller beds; you can carefully trim the Magnetic Base, but the Flexi Plate will stick over your edges, be sure that there are no obstructions such as vertical frame elements, and it is advisable not to have more than 10mms overhang per side to avoid warping. we are not responsible for mistaken order sizes.
▉Some using reference:
▉Photo display:
▉Construct display:
